NOTE
DELIVERY TO WEST MALAYSIA ONLY.
*This product contains liquid/spray, it is not allowed to ship to East Malaysia. Kindly do not place order for Sabah & Sarawak. Thanks.

Product Description:
WD-40 Specialist Fast Drying Contact Cleaner
This product cleans sensitive electronics and electrical equipment.
It also works on larger electric motors, armatures, relays, electric panels and generators.
Ideal for use on: printed circuit boards, controls, switches, tape heads and precision instruments
Safe to use on all plastics, rubber and metal
Excellent for cleaning oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment
It rapidly penetrates into hard to reach areas and dries quickly, without leaving any residue.
Fast acting, non-conductive cleaner
Dielectric strength up to 35,000 Volts per 0.1 inch
ROHS Compliance

Direction of use:
Shut off all power and allow any hot surfaces to cool.
Shake the can well and apply by spraying directly on surface to be lubricated and protected.
Hold the can 6 to 8 inches away from the surface
Spray directly on to the electrical device or circuit board
To eliminate and remove any contaminants that may cause loss of electric contact.
Tilt surface while cleaning and allow any excess cleaner to run off.
Allow product to dry completely and through
Vent the system before restoring power.

Variation:
A200mL
B360mL