Size (length*width*height): 54cm x 10cm x 5cm

What's in the box:

• 1 x Thermaltake V-Tubler PETG Tube 5/8 A 16mm OD 12mm L 500mm 4pcs CL-W065-PL16TR-AA1000786

Cautions

• Thermaltake Recommends The Following Steps To Be Taken After Completing Your Water Loop Setup
• It Is Strongly Recommended To Use Market Proven Pre-Mix Coolant, Such As Thermaltake Coolant 1000. It Offers Great Performance While Preventing The Entire Cooling System Copper, Brass, Nickel, Aluminum, And Steel From Corrosion
• Fill The Reservoir With Coolant And Cycle The Power On And Off Several Times While The Pump Pushing The Coolant Into The Loop
• DoNotLet The Pump Run Dry, When There Is No Liquid Entering The Pump Turn Off Your Power Immediately
• Fill The Reservoir To The Top As It Will Prevent Air From Going Into The Pump
• If Necessary Tilt The System Slightly From Side To Side To Bleed The Air Out Of The Loop
• Place Some Paper Towels Under Fittings And Joining Points To Test For Leaks
• Run The Loop With The Fill Port Open For About 24 Hours To Completely Bleed The Air Out Of The Loop
• Before Starting, Flush Out Your System Correctly To Prevent Any Coolant Or Unwanted Particles Sticking To Your Tubes, Radiators And Other Cooling Components
• Coolant Might Fade Over Time

Specifications

What In The Box

• 1 x Thermaltake V-Tubler PETG Tube 5/8 A 16mm OD 12mm L 500mm 4pcs CL-W065-PL16TR-AA1000786

Warranty
No Warranty