Product Information
Size (length*width*height): 6cm x 6cm x 10cm
*DUE TO CMCO, LIQUID ITEM CAN'T BE POSTED TO SABAH AND SARAWAK, BUT PLEASE DO CONTACT US FIRST*WEIGHT : 50g
This is the disperse dye auxiliaries (DYE FIXING AGENT, LEVELLING AGENT, ANTI FOAMING AGENT, ACCELERATOR, DISPERSING AGENT) - All in one solution. This solution will help you to have a good quality of your polyester/wool fabrics with the disperse dye of your choice.
Anti-foaming agents prevents fabric padding mangles, bubble formation and it disrupts spots formation in the dye).
, Accelerators(Also called carriers, It accelerates the rate of dyeing of disperse dyes on polyester fibre materials when dyed at boil at atmospheric pressure and they also alter the dispersing properties of the dyes and the physical characteristics of the fibre so that more of the dyestuff can be transferred from the dye bath to the fibre than in the absence of the carriers).Dye fixing agents it allows strong fastness to fabric,
Stripping agents. It is sometimes necessary to remove the dye from dyed material in order to correct the faulty dyeing.
PROCEDURES FOR DYEING WITH DISPERSE DYES USING HIGH TEMPERATURE.
( PLEASE NOTE THAT CAREFULNESS AND CAUTION IS NEEDED WHEN HANDLING HOT WATER)
1.Get a bucket or a bowl and pour 1 litre of boiled water of about 100 - 130 degree centigrade into the bucket or bowl.
2.Press from the tube about 20g of disperse dye into the hot water and stir.
3.Pour the AUXILARIES (20g Dispersing Agent) solution given in a 50ml bottle, measure about 20g of the solution and pour it into the hot disperse dye solution (and stir).
4.Pour your Dye Fixing Agent
5.Pour your Levelling Agent to acquired the required alkaline level with PH test kit, which falls between 4 and 7 test scale. (If need be, add an extra Levelling Agent to acquire the ratio of between 4 and 7 test scale and stir again).
6.Then, pour about 10ml of Anti-foaming agent (stir) .
7.Deep your fabric material such as polyester/wool substrate into the hot solution then stir the substrate and wait for about 5 minutes. Pour the dispersed dye solution containing the substrate/polyester or wool into a deep pot and then switch on the stove or reheat the temperature back to 100-130 degree centigrade, while boiling for another 3-5 minutes, pour 10g of Accelerator into the substrate. (WARNING, BECAREFUL OF HANDLING HOT WATER, MAKE SURE TO USE A WOODEN SPATULA TO STIR in the solution.), switch off the stove and allow your project to cool for about 5-6 hours (soaking) so that the substrate would properly absorb the dispersed dye.
8. After soaked , stir before bringing out the fabric (DO NOT SQUEEZE THE FABRIC to avoid irregular lines on your polyester fabric, if your project is a T-shirt dyeing use hanger to hang the T-shirt and leave it to drip until dry.)
9.Once dried, pour a clean warm water of about 2 litres and pour the dye fixing agent into the water, and deep your fabric to rinse and stir. Then leave it for another 10-20 minutes to fix.
10.Finally, rinse again with plain normal w

Shipping Information
Zone | Weight | Delivery Fee (RM) |
---|---|---|
West Malaysia | First 3.00 kg | 6.00 |
Extra 1.00 kg | 2.00 | |
East Malaysia | First 0.50 kg | 14.30 |
Extra 0.50 kg | 5.10 |