What's in the box:

No Data

How to USE:

1.Select the appropriate voltage and connector for the electronic device to charge / power supply.

2.Press the switch to start charging when your device connected with EPOWER; If you unplug the

cable, auto-sleep will start in one minute.

3.Five lights will flash circularly during the charging by EPOWER and all lights will keep bright when

your device is full-charged.

4.During the charging for your device, LED lights indicate the balance power of built-in battery of

EPOWER. Four lights indicate 80% balance, 3 lights indicate60% balance, two lights indicate 40% balance and one light

indicates 20% balance. The built-in battery is empty when all LED lights start to flash.

5.Press the switch five seconds to start If you want to use LED for illumination and select the

status ( light, strobe, SOS, close) by pressing the switch to transform.

6.Store the product in a cool and dry place and away direct sunlight.

Caution:

To avoid cause accidents, make sure note the following cautions:

1. Take off the main unit within 30 seconds after starting the car.

2. Don't clip the two terminals at the same end on the battery.

3. Don't Disassemble the unit!

Application:

Car, mobile phone

1: Car emergency start charging(Only works for gasoline Car 12V,

Have been tested, this jump starter can start 5.0 liter gasoline engine but can't

start diesel engine)

2:SOS Flashlight